Control Panel; Reset Menu - Beretta MYNUTE X C Installer And User Manual

3.19

Control panel

A
B
Led
Light signal indicating the operating status of the boiler. Can be red or green (see specific paragraph).
A
It is normally used to raise the domestic hot water temperature, when the arrow
B
It is normally used to lower the domestic hot water temperature, when the arrow
A+B
Access to the domestic hot water comfort functions (see paragraph "4.13 Domestic hot water comfort function")
C
It is normally used to raise the heating water temperature, when the arrow
D
It is normally used to lower the heating water temperature, when the arrow
C+D
When heating programming timing is enabled, it allows you to pass from the automatic program to the manual one
A+C
Access to the menu for setting the clock (see paragraph "4.2 Programming the boiler")
B+D
Access to the programming timer menu (see paragraph "4.3 Time band scheduling function (room thermostat)"
1
Used to change the operating status of the boiler (OFF, SUMMER and WINTER)
2
Used to reset the alarm status or to interrupt the vent cycle
3
Used to access the INFO and SETTINGS menus. When the icon
during the programming of a technical parameter
1+3
Lock and unlock keys
2+3
When the boiler is set to OFF it is used to start the combustion analysis function (CO)
+
RESET
1 2
Enter
is shown on the display, the key has the ENTER function and is used to confirm the value set
+
MENU
3
is highlighted it has the confirm function
is highlighted it has the back/cancel function
is highlighted you can move inside the setting menu
is highlighted you can move inside the setting menu
LED
C
D
ENGLISH
9