Beretta MYNUTE X C Installer And User Manual page 10

MYNUTE X
Structure of the MENU tree of the REC10
Indicates the pressure at an OT device
Indicates the pressure at a WIFI device
Indicates the pressure of an outdoor temperature sensor
Indicates the activation of special domestic hot water functions or the presence of a system for managing the solar thermal array
Indicates the connection to a heat pump (not used on this model)
Icon that lights up when there is an alarm
It comes on when there is a fault together with the icon
Indicates the presence of a flame, in the event of a flame lockout the icon looks like
Reset
It comes on when there are alarms that require a manual reset by the operator
Enter
It comes on when there is an operation confirmation request
When the icon is active, it indicates that the "confirm" function of button A is active
When the icon is active, it indicates that the "back/cancel" function of button B is active
When the icon is active, it is possible to navigate the menu or raise the value of the selected parameter
When the icon is active, it is possible to navigate the menu or lower the value of the selected parameter
The icon comes on if central heating is active, it blinks if a heating request is in progress
The icon comes on if domestic hot water is active, it blinks if a domestic hot water request is in progress
They indicate the set point level set (1 notch minimum value, 4 notches maximum value)
Indicates the days of the week
1 2 3 4 5 6 7
When the "central heating programming timing" function is enabled this icon indicates that the system heating (main zone) is in AUTOMATIC mode (the management
AUTO ON
of the heating requests follows what has been set with the timer). If we are outside the time band for enabling the heating AUTO OFF is displayed
When the "central heating programming timing" function is enabled this icon indicates that the system heating (main zone) is in MANUAL mode (the management of
MAN ON
the heating requests does not follow what has been set with the programming timing, but it is always active)
MAN OFF
This icon indicates when the "central heating programming timing" is not enabled
10
, except for flame and water alarms