Settings Menu Tree Structure - Beretta MYNUTE X C Installer And User Manual

The remote control has the function of a machine interface, displaying the system settings and providing access to the parameters.
The display normally shows the temperature of the flow sensor unless there is a domestic hot water request in progress, then the domestic hot water probe temperature is displayed; if no
key is touched within 10 sec the current time is displayed (backlight unlit).
The configuration MENU is organised with a multi-level tree structure. An access level has been fixed for each sub-menu: USER level always available; TECHNICAL level password
protected.
Below is a summary of the SETTINGS MENU tree structure.
Some of the information might not be available depending on the access level, the status of the machine or the system configuration.

SETTINGS MENU TREE STRUCTURE

Below is a list of the parameters that can be programmed; if the adjustment board does not support the relative function, the interface returns an error message:
Menu Parameter
SETTINGS
TIME
TIME PROGRAMM
COMB
GAS TYPE
BOYLER TYPE
COMBUSTION OFFSET
CONF
HYDRAULIC CONFIGURATION
WATER TRANSDUCER
AUTO WATER FILL ENABLE
BEGIN SYSTEM FILLING
AIR PURGING CYCLE
MIN
MAX
MAX_CH
RANGE RATED
DO_AUX1
EXHAUST PROBE RESET
CH
HYST ON HIGH TEMP
HYST OFF HIGH TEMP
HYST ON LOW TEMP
HYST OFF LOW TEMP
PUMP CONTROL TYPE
CH POSTCIRC
LOW NOISE
SCREED HEATING
ANTI CYCLE FUNCTION
RESET CH TIMERS
MAIN ZONE ACTUATION TYPE
MAIN ZONE ADDR
MAIN ZONE HYDRAULIC CONF
MAIN ZONE TYPE
MAX CH SET
MIN CH SET
OTR
Value
0 / 1
1 / 2 / 3 / 4
0 / 1 / 2
0 / 1 / 2 / 3 / 4
0 / 1
0 / 1
NOT AVAILABLE ON THIS MODEL
0 / 1
MIN - MAX
MIN - MAX_CH
0 / 1 / 2
0 / 1
2 - 10
2 - 10
2 - 10
2 - 10
0 - 100
NOT AVAILABLE ON THIS MODEL
NOT AVAILABLE ON THIS MODEL
0 / 1
0 - 20min
0 / 1
0 / 1
1 - 6
0 / 1
0 / 1
AT: MIN CH SET - 80.5
BT: MIN CH SET - 45.0
AT: 20 - MAX CH SET
BT: 20 - MAX CH SET
0 (default) / 1
Level Value set
password in the factory
USER
USER
INSTALLER 0
1 (25 kW)
2 (30 kW)
SERVICE
3 (35 kW)
4 (40 kW)
SERVICE
INSTALLER 1
SERVICE 1
SERVICE 0
SERVICE 1
see technical data
INSTALLER
table
see technical data
INSTALLER
table
see technical data
INSTALLER
table
see technical data
INSTALLER
table
INSTALLER 0
INSTALLER 0
SERVICE 5
SERVICE 5
SERVICE 3
SERVICE 3
INSTALLER 85
INSTALLER 0
INSTALLER 3min
INSTALLER 0
INSTALLER 0
INSTALLER 3
INSTALLER 0
INSTALLER 0
80.5
INSTALLER
INSTALLER 20
INSTALLER 0
ENGLISH
Personalised
values
11