User Guide
MHM-97927-PBF
2
Configuration
2.1
Configuration setup
Unless the AMS Wireless Vibration Monitor is purchased pre-configured from the factory,
it needs to be configured prior to installation at the facility or measurement location.
There are three possible setups to configure the device:
1. Connect the device to a field communicator, and then configure the device using
2. Connect the device to a computer through a HART modem, and then configure the
3. Connect the device to a computer through a wireless gateway and then configure
MHM-97927-PBF, DRAFT
the field communicator.
Note
This setup is recommended if you are in a hazardous area.
device using AMS Device Manager.
Note
The HART modem is purchased separately.
the device using AMS Device Manager.
Note
This setup is recommended for standard device configuration.
Configuration
July 2020
13