Emerson AMS User Manual page 71

User Guide
MHM-97927-PBF
B.5 Hazardous locations certifications
Model No:: A9530
Product Name: Wireless Vibration Monitor
The AMS Wireless Vibration Monitor carries certificates for operation in hazardous
locations.
Table B-2: Hazardous locations certifications
CSA C/US
Certificate
CSA20CA8002652
4
IECEx Certificate
IECEx CSA
20.0002X
ATEX Certificate
CSANe
20ATEX2042X
Other approvals
For a complete list of approvals, see the product page at
catalog/ams-a9530.
Conditions for Safe Use
1. Shall be powered only by C-sized lithium primary cell type TL-4920/VE
2. HART Terminal Entity Parameters:
3. The device may be configured using the HART terminals only by 375, 475, or TREX
4. Under certain extreme circumstances, the non-metallic parts incorporated in the
5. The device shall be installed on an earthed metal frame.
Note
Battery may be replaced in hazardous locations. Only replace battery with Tadiran Part
Number TL-4920/VE or Emerson Part Number A0702PPU.
MHM-97927-PBF, DRAFT
Class I Division 1 Groups A, B, C, D
Class I Zone 0 AEx / Ex ia IIC T4 Ga
-40ºC ≤ Ta ≤ +85ºC
Type 4X Enclosure
Ex ia IIC T4 Ga
Ta: -40ºC to +85ºC
II 1 G Ex ia IIC T4 Ga
-40ºC ≤ Ta ≤ +85ºC
IP66
manufactured by Tadiran or Emerson Part Number A0702PPU.
Uo = 5.84V, Io = 116mA, Po =329mW, Co = 0.1µF, Lo = 5mH;
Ui = 5.27V, Ii = 5mA, Pi = 6.6mW, Ci = 13 µF, Li = 0.022mH
field communicators.
enclosure of this equipment may generate an ignition-capable level of electrostatic
discharge. Therefore, the equipment shall not be installed in a location where the
external conditions are conductive to the build-up of electrostatic charge on such
surfaces. In addition, the equipment shall only be cleaned with a damp cloth.
Product certifications
http://www.emerson.com/en-us/
July 2020
71