Chapter 4 Operation - Emerson AMS User Manual

User Guide
MHM-97927-PBF
4 Operation
4.1 Verify the device is operational
You can verify the device operates properly using the following methods:
• Field Communicator
• Emerson Wireless Gateway web interface
4.2 Verify operation with AMS Trex Communicator
You can verify the status of the AMS Wireless Vibration Monitor and configure it using an
AMS Trex Communicator. For instructions on using the AMS Trex unit, see the AMS Trex
Device Communicator User Guide. See
information.
Note
HART Wireless transmitter communication requires a AMS Wireless Vibration Monitor
Device Descriptor file (DD). Refer to the Field Communicator User's Manual for more
details on DDs or go to
Communicator/Pages/SysSoftDDs.aspxhttps://www.emerson.com/en-us/catalog/ams-
trex-device-communicator
Monitor.
Table 4-1: Field Communicator fast key sequence—connect to a network
Key sequence
2, 2, 1 (Manual setup)
2, 1 (Guided setup)
Note
Disconnect the leads when you are finished configuring or troubleshooting. The AMS
Wireless Vibration Monitor does not publish any new vibration data to the gateway while
MHM-97927-PBF, DRAFT
Configuration with a Field Communicator
http://www2.emersonprocess.com/en-US/brands/Field-
for instructions on adding a DD for AMS Wireless Vibration
Menu item
Network ID
Broadcast Info
Join Device to Network
Configure Publishing
Configure Update Rate
Transmit Power Level
Default Burst Config
Configure Sensors
Configure Variable Mapping
Configure Units
Alert Limits
Sensor Power Enable
Join Device to Network
Configure Publishing
Configure Update Rate
Operation
July 2020
for more
45