Calibration Seal Installation; Care And Cleaning - Cardinal 204 Installation And Technical Manual

CALIBRATION SEAL INSTALLATION

If your Model 204 Weight Indicator is used in a commercial application it must be tested and
sealed by your local weights and measurement official. The 204 is designed to accept a lead
and wire security seal to prevent unauthorized access to the calibration adjustments. Refer to
the Figure No. 9 for details on the installation of the seal.
Right End Cap
1. DO NOT submerge indicator in water, pour or spray water directly on indicator.
2. DO NOT use acetone, thinner or other volatile solvents for cleaning.
3. DO NOT expose equipment to temperature extremes.
4. DO NOT place equipment in front of heating/cooling vents.
5. DO clean the indicator with a damp soft cloth and mild non-abrasive detergent.
6. DO remove power before cleaning with a damp cloth.
7. DO provide clean AC power and adequate protection against lightning damage.
8. DO keep the surroundings clear to provide clean and adequate air circulation.
8555-M313-O1 Rev H • 204 Installation & Technical
20
(Indicator as viewed from rear)
Figure No. 9

CARE AND CLEANING

Left End Cap