Parameterisation - SMC Networks EX245-SPN1 Operation Manual

4.2. Parameterisation

4.2.1. System parameters
The SI unit has the following system parameters.
Parameters
US1 Diagnosis
US2 Diagnosis
US3 Diagnosis
US4 ... US10
Diagnosis
NOTE
・ The parameters "US3 Diagnosis" and "US4 ... US10 Diagnosis" are options which can be
enabled to use a special module.
Table. 4-1 System parameters
Range of values
Enable
Enable
Disable
Enable
Disable
Disable
Enable
Disable
Disable
Enable
Disable
Disable
Default
When this parameter is enabled, the system
generates a diagnostics event if it detects that
US1 has dropped or off.
When this parameter is enabled, the system
generates a diagnostics event if it detects that
US2 has dropped or off.
When this parameter is enabled, the system
generates a diagnostics event if it detects that
first additional loads supply (US3) has dropped
or off.
When this parameter is enabled, the system
generates a diagnostics event if it detects that
one of additional loads supplies excluding the
first one (US4, US5, etc.) has dropped or off.
-23-
Meaning
No.EX##-OMU0020-A