DMX Mode
Allows the unit to be controlled by any universal DMX controller.
1.) The default mode for the fixture is DMX, which appears as
select a different DMX address, using the <MENU> button, select
Use the <UP/DOWN> buttons to select the correct address, then hit <ENTER> to confirm.
Setting the DMX Channel Mode:
1.) To select a DMX channel mode, press the <MENU> button, then use the <UP> or
<DOWN> buttons until the display reads
the <UP> or <DOWN> buttons until the display reaches your desired channel mode. Press
the <MENU> button to confirm.
Stand-Alone, Master/Slave, Sound Active Modes:
Allows a single or Master/Slaved units to run factory installed programs at user selectable speeds.
1.) To set the fixture in Flash/Fade mode, select
<ENTER> button.
2.) Now, you can adjust the flash settings from
FA00-FA15.
3.) To use the fixture in automatic mode, select
use the <UP/DOWN> to choose from
confirm.
4.) Adjust the speed of the chase as above using
press the <ENTER> button to confirm.
5.) To set the fixture as a slave unit, select
SL.AU
flashing
Sound Active Mode:
1.) To use sound active mode, select
Standalone (Program) Mode:
Allows a single unit to display a variety of colors and programs without a DMX controller.
1.) To set the fixture in manual mode, select
To confirm, press the <ENTER> button.
2.) Now, select the program by using the <UP> and <DOWN> buttons to select
Pr15
. To confirm, press the <ENTER> button.
Manual Color Adjustment:
Allows the user to adjust the color balance of the fixture. These settings are global, they will effect all
modes.
1.) Use the <MENU> and <UP/DOWN> button to select
bL--
Level),
2.) Using the <UP/DOWN> buttons, select the maximum level for each color between
x255
(000=off), then hit <ENTER> to confirm.
RokBox Manual Rev. A
Then press the <ENTER> button to confirm.
to indicate it is in slave mode.
UL--
(Blue Level) or
Page 12
Chnd
and press the <MENU> button. Then use
FLAS or FAdE
FL00-FL15
ASC-
, and press the <ENTER> button. Then
AS00-AS15
, then press the <ENTER> button to
SP15
(slowest) to
SLAU
, and hit <ENTER>. The unit will display a
SouA
, then press the <ENTER> button to confirm.
Pr--
.
rL--
(White Level), then hit <ENTER>.
d001
on the LED Readout. To
Addr
,then hit <ENTER>.
. To confirm, press the
or the fade settings from
SP00
(fastest) then
Pr00-
GL--
(Red Level),
© 2013 Blizzard Lighting, LLC
(Green
x000-