Changing Front Axle Case Oil - Kioti DK4210(C)HSE Manual

(1) oil Dipstick (2) oil filler Plug
(a) oil level is acceptable within this range
5. Apply a thin film of clean oil onto
the O-ring of a new filter.
6. Tighten the filter until it touches the
mounting surface. then, tighten
the filter for a half turn further with
a hand.
7. After installing a new filter, run the
engine for a few minutes and stop
it.
8. check the oil level again and add
more oil to the specified level.
TD210-미국법인향-DK4210,4710,5310,60119 19
Oil Capacity
11.36 u.s.gal. (43 l)
CAUTION
To avoid injury:
•
Be sure to stop the engine
before changing the fluid or
replacing the filter.
•
Cool down the fluid sufficient-
tD2o704a
ly. you can get burnt by hot
fluid.
IMPORTANT
•
To prevent serious damage to
the hydraulic system, use only
a KIOTI genuine filter.
•
Do not operate the tractor
immediately after changing
transmission fluid. Run the
engine at medium speed for a
few minutes to prevent dam-
age to the hydraulic system.
maintenance
ChANGING FRONT AxlE CAsE
OIl (N)
(1) oil filler Plug (2) Drain Plug
1. remove the drain plugs from the
front axle case (lh/rh) and front
axle support to drain oil.
2. after draining, reinstall the drain
plugs securely.
3. remove the bleeding plug from the
front axle case and add oil through
the filler hole.
Oil Capacity [U.s. gal(l)]
1.48 (5.6)
7
1
-
tD2o714a
5 7
2019-09-18 오후 4:53:34