Checking And Replacing Wiper - Kioti DK4210(C)HSE Manual

7
3 Dk4210(c)hse / Dk4710(c)hse / Dk5310(c)hse / Dk6010(c)hse
-
CAUTION
•
Never bleed the fuel system
while the engine is hot.
IMPORTANT
•
After bleeding, fuel without
air bubbles is filtered by the
fuel filter and is transferred
to the fuel injection pump.
Maintain the proper fuel level
in the fuel tank before the fuel
tank becomes empty. If all fuel
is completely consumed in
a Diesel engine, fuel should
be added to the fuel tank and
then the fuel system should
be bled.
NOTE
•
if the engine cannot be started
even after bleeding the fuel sys-
tem, contact your local Dealer.
TD210-미국법인향-DK4210,4710,5310,60134 34
ChECkING AND REPlACING WIPER(AM)
INsPECTION
1 1
(1) wiper
check the operation and wear of the
wiper blades frequently. to replace the
wiper blade, press the wiper fixing le-
ver to separate it and then pull it away.
to remove the wiper arm, lift the cap
of the wiper arm, remove the nut,
and set the wiper arm upright. then,
hold the arm head and shake it left
and right to remove the wiper arm
from the drive spindle. Disconnect
the washer fluid hose and then install
a new wiper arm to its position by
aligning it to the proper angle.
REPlACEMENT
t21o460a
(1) wiper arm (2) wiper fixing lever
(3) wiper Blade
1. set the wiper upright to replace the
wiper blade.
2. hold the blade with one hand and
press the blade fixing lever with
the other hand to separate the
blade from the fixing part.
h11o649a
2019-09-18 오후 4:53:43