Figure 4-7. Fiber Connections - ADTRAN Total Access 300 Series Installation And Maintenance Manual

Fiber Jumper
5. Using the Fiber Jumper supplied with the Electronics Module, connect one end to the
6. Before closing the Electronics Module, route all wires as shown in
7. Close the Electronics Module and secure by tightening the "Inner Security Screw".
!
CAUTION
Use caution when routing wires and cables. Avoid severe bending and
routing over sharp edges.
NOTE
When the OptiTap connector is not in use, replace the protective covers and
the end caps on the Bulkhead Connector to help keep the optics clean.
612877GONT-5C
OptiTap Connector and the other to the optical connector on the bottom of the
Electronics Module.
Incoming Fiber

Figure 4-7. Fiber Connections

Figure 4-7.
4-13