Pr39 - Non-Linear Compensation; Pr40 - Non-Linear Compensation Interval; Pr41 - Temperature Compensation; Pr42 & Pr43 - No Longer Used - Accurate Technology ProScale 950 Series Operation

Pr39 through Pr44 apply to General Purpose E and 950 Series Readouts
(Firmware versions end in 'C')
Pr39 – Non-Linear Compensation
This parameter Enables/Disables the
Default Value = 0
Pr 39 Setting
Pr40 – Non-Linear Compensation Interval ··················· [0.5 to 10.0 in.]
This parameter sets the distance interval used while performing non-linear
compensation calibration.
Default Value = 5.000 in. (127mm)
Pr41 – Temperature Compensation ····································· [0 or 1]
This parameter enables (disables) the
Default Value = 0
Pr 41 Setting
Pr42 & Pr43 – NO LONGER USED
Pr44 – Temperature Compensation Coefficient ··················· [10 to 999]
This parameter sets the temperature expansion coefficient used when
temperature compensation Pr41 = 1.
Default Value = 150
Range: 10 to 999 will yield values from 1.0 m/m °K x 10
Note: Coefficients MUST be in m/m °K.
Manual Part # 800-1402-002 Rev K, 072418
0
1
0
1
·········································· [0 or 1]
Non-Linear Compensation
Non-Linear Compensation
Off
On
temperature compensation
Temperature Compensation
Off
On
function.
feature.
-6
to 99.9 m/m °K x 10
Page 49 of 53
-6.