Enter Programming Mode; Navigating Programming Mode - Accurate Technology ProScale 950 Series Operation

Enter Programming Mode

Press and Hold the
LCD will briefly display: PG on (Programming On). Release both keys. The
LCD will then display Pr 1, (indicating Programming Parameter #1) for about 1
second, then display the value stored for

Navigating Programming Mode:

To move up Parameter list:
Momentarily press the
Programming Parameter list. The Readout will display the Parameter
number, then the current programmed value.
To move down Parameter list:
Press and Hold the
backward through the Parameter list.
To Increase a Parameter value:
Momentarily press the plus (+) key while the
Parameter value is displayed.
To Decrease Parameter value:
Momentarily press the minus (-) key while the Parameter value is
displayed.
To Reset a Parameter value to the Factory Default setting:
Momentarily press the
displayed.
Operation Manual for LCD Digital Readouts
key while Momentarily pressing the
UNITS
Press & Hold
Video demonstration
key to advance up through the
UNITS
/ key and Momentarily press the
ON OFF
key while the Parameter value is
DATUM
.
Pr1
Momentarily press
key. The
DATUM
key to move
UNITS
Page 42 of 53