Fundamental Readout
Functions
Auto On/Off Timer
To prolong battery life, the Readout has a built-in function that turns off the
Readout after a period of no movement or key activity. The Auto On/Off
function is programmable from 0 (always on), to 240 (minutes) before entering
sleep mode.
Press the
/
ON
OFF
Readout. Any key press or system motion while the Readout is awake restarts
the Auto On/Off timer. Use
Reading Direction
If the direction of readings, (increasing vs. decreasing) is opposite the desired
direction, use
Programming Parameter (Pr2)
Resolution
The Readouts have four selectable display resolutions.
Fractions display mode is not affected by resolution changes.
.1in
.01in
.001in
.0005in
Use
Programming Parameter (Pr4)
Data displayed (and sent to the SPC output) is auto-ranging. This means the
selected resolution may be temporarily overridden if the measurement or
position to be displayed exceeds the maximum displayable value for the
programmed resolution. The Readout will continue to automatically reduce the
resolution to 1 decimal place or until an allowable resolution is achieved. The
available resolutions are:
Millimeter Resolution
Manual Part # 800-1402-002 Rev K, 072418
key or move the measurement system to wake up the
Programming Parameter (Pr12)
.1mm
.01mm
.01mm
.01mm
Inch Resolution
4 decimal places
3 decimal places
2 decimal places
1 decimal place
2 decimal places
1 decimal place
to reverse the Reading Direction.
.1cm
.01cm
.001cm
.001cm
to set the displayed resolution.
Maximum Displayed Value
Maximum Displayed Value
to set this interval.
or
or
or
99.9999
999.999
9999.99
99999.9
9999.99
99999.9
Page 19 of 53