Readout Key Functions
On/Off Key
Momentarily Press
Momentarily press the
(The Readout Firmware (F/W) version displays for two seconds at power-on.)
Units Key
Momentarily press the
(16ths, 32nds and 64ths) and metric (millimeters or centimeters) measuring
modes. To configure the measurement modes that are displayed when
pressing the
UNITS
When the Readout is in 1/16 or 1/32 inch fraction mode,
a series of "bars" may appear in the upper right corner of
the LCD. Each bar represents 1/64th of an inch. (i.e. when in 1/16 fraction
mode and three bars appear, the measurement displayed is rounded down to
the closest 1/16 inch, plus each illuminated bar represents an additional 1/64 of
an inch, for an actual fractional measurement of 7/64ths of an inch.) For better
resolution, switch to 1/32 or 1/64 mode. Or better yet, to decimal Inches.
In Fractions mode, when the measurement is greater than
99 63/64 inches, +100 and/or +200 will illuminate in the upper right portion of
the LCD to indicate this amount must be added to the displayed reading. (i.e.: If
the measurement is 154 5/8 inches, 54 5/8 and +100 will appear on the LCD, If
the measurement is -307 23/64 inches, - 7 23/64, +100 and +200 will appear on
the LCD.
Manual Part # 800-1402-002 Rev K, 072418
/
key to turn the Readout on or off.
ON
OFF
Momentarily Press
key to cycle through decimal inches, fractions
UNITS
key use
Programming Parameter (Pr11).
Page 17 of 53