S
2
ECTION
Mounting the Readout
Basic , 950, General Purpose
These Surface Mount Readouts may be mounted:
•
Using Velcro or Double sided tape applied to the back side
•
Drilling out the 3 holes (see below) from the inside of the case
•
Using any of the six holes on the back of the case (M2 or 4-40 screws)
¼ DIN In-Panel
A cutout should be made in the panel at least 90mm x 90mm (3.6 x 3.6 inches),
but no larger than 93mm x 93mm (3.7 x 3.7 inches).
The cases of the Readout are designed to "sandwich" panel thicknesses
between 3mm (0.125") and 20mm (0.750").
NOTE: If the panel is thinner than 3mm (0.125 in), shorter screws must be
used for the Readout casing or damage to the front cover of the Readout will
occur.
Operation Manual for LCD Digital Readouts
I
NSTALLATION
Page 12 of 53