Hold
The Readout provides a feature that allows the displayed
measurement or position to be "held". This allows information
to be captured on the Readout and held for later viewing
regardless of the current Encoder position.
To activate the HOLD, Momentarily press the
in the upper left corner of the LCD. The currently displayed position and
selected key presses will be held.
To release the HOLD feature, Momentarily press the
power.
NOTES:
•
If power is cycled when HOLD is active, any key (such as
,
DATUM
when power is restored.
•
Leaving the normal measurement mode, (i.e. enter programming
mode, SEND, or using the Go/No Go editor) causes the Readout to
automatically exit HOLD.
Delete
Momentarily pressing
output data port. When a ProRF Transmitter is attached to this
port, a "delete" message will be sent to the ProRF Receiver.
This "delete" message removes the last measurement from a cut list when
connected to another device such as an automated stop or cutting system.
Manual Part # 800-1402-002 Rev K, 072418
–)
+
or
that is depressed while in HOLD will be executed
sends a special "delete" signal to the
F2
key. HOLD will be displayed
F4
key again, or cycle
F4
Page 25 of 53
,
UNITS