Table of Contents
Advertisement
Pr 14 Setting
Pr21 – NOT USED
Pr22 – ABS/INC Key Operation ··············································· [0 or 1]
This parameter controls the amount of time the
pressed to enter the INCremental measuring mode.
Default Value = 0
Pr 22 Setting
Pr23 – Auxiliary Keypad Enable ·············································· [0 to 3]
The parameter controls the operation of the
Default Value = 3
Pr 23 Setting
Pr24 – Special Functions ······················································· [0 to 4]
This parameter controls which
Default Value = 0
Pr25 – Special Function Variable ··········································
The parameter may be used by a special function to customize it's operation.
See
Advanced Programming Function
used.
Default Value = 0
Pr26 – Drift Monitor Tolerance
This parameter sets the amount of drift that must occur in
trigger a drift indication.
Default Value = .01 in
Operation Manual for LCD Digital Readouts
0
1
0
1
0
1
2
3
Advanced Programming Function
Pr24 Setting
0
1
2
3
4
Technology Supported
Model 180, 280, 380 and 580 Systems
Model 150, 250 and 950 Systems
Key press to enter INCremental mode
Press and Hold ABS/INC key (1.2 sec)
Momentary depress ABS/INC key (< 1 sec)
ABS
ABS/INC and SEND keys
Disable Both Keys
Enable abs/inc Key only
Enable send Key only
Enable Both Keys
Advanced Readout Function
F3 = MON, F4 = HOLD, F2 = Delete
Measurement Accumulation
for instances when this parameter is
[
.01 mm to 3048 mm] or
/
key needs to be
ABS
INC
/
and
keys.
INC
SEND
None
Go/NoGo
Statistics
[
.001 in to 120 in]
MONitor
Page 46 of 53
is active
[
0 to 16]
mode to
Advertisement
Table of Contents
