Table of Contents
Advertisement
Measurement Units
The different measurement units displayed on the Readout are user
configurable. The table below provides a matrix for selecting the measurement
units that may be displayed when pressing the
Use
Programming Parameter (Pr11)
Programming Parameter Pr 11 Value
Key Lock
The Readout provides a function that can "lock-out" the position adjustment
keys (+,
DATUM
To activate Key Lock: Press and Hold the
Momentarily depress the
will be displayed in the upper left corner of the LCD.
Press & Hold
When LOCK is displayed on the LCD, the +,
function to change the readout. To de-activate the Key Lock: Press and Hold
the
/
key and, while pressing it, Momentarily depress the
ON
OFF
release both keys. Key Lock may also be enabled through Readout
Programming. This method allows a more permanent Key Lock since
programming can be disabled with a hardware jumper inside the Readout.
See
Programming Parameter (Pr3)
Linear Scaling
This function is useful when the actual measurement or position must be
multiplied or divided before being displayed on the Readout.
This function has a range of 0.0001 to 9.9999 allowing the actual measured
value to be multiplied or divided in very small or very large increments.
See
Programming Parameter
Use care when enabling this function. It will force the readout to display a value
different from the actual measurement or position.
Operation Manual for LCD Digital Readouts
0
1
2
3
4
5
6
& –) to prevent accidental changes of the displayed value.
UNITS
Momentarily Press
(Pr13)
to set this value.
Measurement Units Displayed
All inch units, & millimeters
Decimal inches & millimeters
Decimal inches & centimeters
All inch units, & centimeters
Decimal inches only
/
ON
OFF
key, now release both keys. The word LOCK
DATUM
to enable this function.`
for additional information.
key.
UNITS
Millimeters only
Centimeters only
key and, while pressing it,
and – keys will not
Page 20 of 53
key, now
UNITS
Advertisement
Table of Contents
