Attach Tarp Frame - KidKraft TREASURE COVE Installation And Operating Instructions Manual

Step 22: Attach Tarp Frame
Part 1
A: On the Front and Back Walls place 1 (2786) Roof Side on top of each (2775) Panel Cross Support so the
extension on the Swing Wall measures 9-1/4" and the extension on the End Wall measures 18-1/8" then attach
with 4 (S4) #8 x 3" Wood Screws per board. (fig. 22.1 & 22.2)
B: Place 1 (2785) Roof Upright on the inside of each wall, flush to the bottom of (2775) Panel Cross Support then
loosely attach to (2786) Roof Side from the outside with 1 (H3) 1/4 x 2-1/2" Hex Bolt (with lock washer, flat washer
and t-nut) per board. (fig. 22.1 & 22.2)
C: Make sure (2785) Roof Upright is square then attach to (2775) Panel Cross Support from the inside with 2
(S11) #8 x 2" Wood Screws per board. Tighten both bolts. (fig. 22.1 & 22.2)
Fig. 22.2
TN1
2775
Wood Parts
2 x Roof Side 1-1/4 x 2-1/4 x 70-3/4"
2786
2 x Roof Upright 1-1/4 x 2-1/4 x 29-1/2"
2785
Fig. 22.1
Swing
Wall
S4
2785
S11
8 x
S4
2 x
H3
4 x
S11
Front Wall
9-1/4"
Back
Wall
FW1
S4
H3
LW1
Hardware
#8 x 3" Wood Screw
1/4 x 2-1/2" Hex Bolt
(1/4" lock washer, 1/4" flat washer, 1/4" t-nut)
#8 x 2" Wood Screw
47
18-1/8"
2786
End Wall
2786
Tight