Table of Contents
Advertisement
Rigging procedures
When KARAIIi-TILTBRACKET is secured to Kara IIi with the angle bracket at the front, the grills cannot be removed
and KARAIIi-SCREEN cannot be secured on the enclosure.
The grills on the rst enclosure can be exchanged before rigging. Refer to
Assembly
Procedure
1. Secure KARAIIi-TILTBRACKET to the ceiling using M10 screws and fasteners.
Fasteners for ceiling-mounting
Select screw length and anchors applicable to the ceiling properties.
Model the array in Soundvision and check the loads on rigging in the Mechanics view.
2. Prepare a Kara IIi.
a)
Risk of acoustic leaks
Do not remove the placeholder screws from the bottom rear inserts (A or B) that are not used.
Remove the relevant placeholder screws.
At the bottom rear, remove placeholder screws "A".
b) Secure KARAIIi-LINK on the enclosure.
For an array of one enclosure, secure KARAIIi-ENDLINK instead.
68
778 mm / 30.6 in
B
A
Exchanging Kara IIi grills
Ø 12 mm / 0.5 in
A
Kara IIi owner's manual (EN) version 2.0
(p.92).
B
Advertisement
Table of Contents
