Table of Contents
Advertisement
Ceiling-mounting
Mounting a Kara IIi array with KARAIIi-TILTBRACKET
Type of deployment
Rigging accessories
Screws and fasteners
Tools
Min. number of operators
Rigging plates
x2
KARAIIi-TILTBRACKET
Fastening brackets
with angles for Kara IIi
Fasteners for ceiling-mounting
Select screw length and anchors applicable to the ceiling properties.
Model the array in Soundvision and check the loads on rigging in the Mechanics view.
Mounting KARAIIi-TILTBRACKET to the ceiling
When mounting Kara IIi to the ceiling with KARAIIi-TILTBRACKET, Kara IIi must be turned upside-down (logo on
the left-hand side).
Otherwise, it is not possible to mount additional Kara IIi under the rst one, and the site angle is not accurate.
For aesthetic purposes, the front grills can be removed and exchanged when the enclosures are assembled. Refer
to
Exchanging Kara IIi grills
Kara IIi owner's manual (EN) version 2.0
ceiling-mounted
KARAIIi-TILTBRACKET
Kara IIi rigging plates
M6×18 Torx rigging screws (provided)
4 × M10 screws and anchors
torque screwdriver
T30 Torx bit
3
x2
KARAIIi-LINK
KARAIIi-ENDLINK
Rigging plates
End rigging
for Kara IIi
plates for Kara IIi
(p.92).
x2
Rigging procedures
67
Advertisement
Table of Contents
