Connection to LA amplied controllers
Cabling Kara IIi and SB18 IIi
Accessories
Screws and fasteners
Tools
Min. number of operators
Assembly
Prerequisite
The cable glands on the connector sealing plates are compatible with cables up to 4 × 4 mm² gauge.
• Refer to
Recommendation for speaker cables
• Refer to
Cabling schemes
About this task
The connector sealing plates have two cable glands: one for the input cable and one for the cable connecting to the next
enclosure in parallel. The second cable gland is equipped with a protective plug.
This procedure describes how to connect the input cable to the enclosure. If the enclosure must be connected in parallel,
remove the protective plug from the second cable gland and proceed identically for both cables.
Procedure
1. On the connector sealing plate, remove the sealing nut from the cable gland.
100
connector sealing plates
M5×16 Torx screws (provided)
torque screwdriver
T25 Torx bit
small tool or at screwdriver (3 mm or less)
1
(p.139).
(p.98).
Kara IIi owner's manual (EN) version 2.0