Installing The Lens - Christie CineLife+ 4K-RGB Installation And Setup Manual

4. Remove the protective cap from the UPS input plug.
5. Connect the UPS input plug to the top power supply (A).
6. Place the protective cap from the UPS plug on the MAIN input plug.
7. Reinstall the rear panel of the projector.
8. Reinstall the projector touch panel.
9. Plug in the appropriate UPS power cord to the UPS and then into the UPS input (Input B) on
the projector.

Installing the lens

The lens seals the projection head, preventing contaminants from entering the main electronics area.
Before installing the lens, ensure that you turn off the projector and the circuit breaker switches.
Do not operate the projector without a lens installed. Install a lens plug when you install or transport
the projector.
1. Remove the lens caps from the front and rear of the lens.
Lens caps must be removed or they can melt and damage the lens.
2. Position the lens so that the UP label is facing upward.
CineLife+ 4K-RGB Installation and Setup Guide–CP4415-RGB, CP4420-RGB
020-103244-04 Rev. 1 (03-2021)
Copyright © 2021 Christie Digital Systems USA, Inc. All rights reserved.
Installing and setting up
24