Table of Contents
Advertisement
8.12 DHW pump
8.13 H Output
8.14 Movable grate open
8.15 Movable grate colose
9 Chimney sweep mode
9.1 Chimney sweep mode
9.2 Boiler output setting
9.3 Work time
10 Alarms
The menu contains information about faults that occurred during boiler operation. 100
faults are recorded and then overwritten.
11 Turn on / off controller
Allows you to turn the controller on / off. The controller can also be switched on by touching
the "Boiler off" icon on the screen.
SERVICE SETTINGS - ENTER THE PASSWORD:
12 Boiler settings
The menu contains settings related to the boiler service settings.
12.1 Output modulation
12.1.1 Feeder cycles
12.1.2 Maximum boiler output
12.1.3 The intermediate boiler output
12.1.4 Minimum boiler output
12.1.5 Blow-in fan output 100%
12.1.6 Blow-in fan output 50%
12.1.7 Blow-in fan output 30%
12.1.8 50% H2 Hysteresis
12.1.9 30% H1 Hysteresis
12.1.10 Boiler hysteresis
12.1.11 Regulation mode
12.1.12 Room thermostat
12.2 Firing-up
12.2.1 Fuel dose
12.2.2 Ignition test time
Check time to see if the burner is lit. Only the fan works.
12.2.3 Ignition pre-heating time
12.2.4 Firing-up time
Ignition time. After this time and the ignition fails, the controller proceeds to the next ignition
attempt.
12.2.5 Incandescence time
Ignition time after flame detection in the ignition phase.
12.2.6 Blow-in fun output INC
Burner fan power in the combustion phase.
12.2.7 Firing-up end flame
Flame threshold at which the controller detects that the boiler is already on fire. It is also
used to detect fuel shortages and burnout.
12.2.8 Blow-in output fire-up
Fan power during ignition. Too high a value prolongs the ignition process or causes an
32
Advertisement
Table of Contents
