Emerson Micro-Motion 2400S Configuration And Use Manual page 92

Optional Configuration
Table 8-7 Status alarms and severity levels continued
Communicator message
Alarm code ProLink II message
A016 Line RTD Temperature Out-Of-Range
Line RTD Temperature Out-of-Range
A017 Meter RTD Temperature Out-Of-Range
Meter RTD Temperature Out-of-Range
A020 Calibration Factors Unentered
Calibration Factors Unentered (FlowCal)
A021 Unrecognized/Unentered Sensor Type
Incorrect Sensor Type (K1)
A029 Internal Communication Failure
PIC/Daughterboard Communication Failure
A030 Hardware/Software Incompatible
Incorrect Board Type
A031 Undefined
Low Power
(1)
A032 Meter Verification Fault Alarm
Meter Verification/Outputs In Fault
(2)
A032 Outputs Fixed during Meter Verification
Meter Verification In Progress and Outputs
Fixed
A033 Tube Not Full
Tube Not Full
(2)
A034 Meter Verification Failed
Meter Verification Failed
(2)
A035 Meter Verification Aborted
Meter Verification Aborted
A100 Primary mA Output Saturated
Primary mA Output Saturated
A101 Primary mA Output Fixed
Primary mA Output Fixed
A102 Drive Over-Range
Drive Overrange
A104 Calibration-In-Progress
Calibration in Progress
A105 Slug Flow
Slug Flow
A106 Burst Mode Enabled
Burst Mode Enabled
A107 Power Reset Occurred
Power Reset Occurred
84
Default
severity Configurable
Fault Yes
Fault Yes
Fault Yes
Fault No
Fault No
Fault No
Fault No
Fault No
(3)
Varies No
Fault No
Info Yes
Info Yes
Info Yes
Info Yes
Info Yes
Info Yes
Info Yes
Info Yes
Ignore Yes
®
Micro Motion Model 2400S Transmitters with Analog Outputs
Affected by
fault timeout
Yes
Yes
No
No
No
No
No
No
No
Yes
No
No
(4)
No
(4)
No
No
(4)
No
No
(4)
No
No