Emerson Micro-Motion 2400S Configuration And Use Manual page 106

Pressure Compensation, Temperature Compensation, and Polling
Figure 9-3 Configuring external temperature compensation with ProLink II
Enable
View Menu >
Preferences
Enable Use External
Temperature
Apply
(1) Temperature measurement unit must be
configured to match temperature unit
used by external device. See Section 6.4.
(2) See Section 9.4.
(3) If previously configured. Polling for
pressure is allowed. See Section 9.4.
Figure 9-4 Configuring external temperature compensation with the Communicator
Set temperature measurement unit
On-Line Menu >
(1) Temperature measurement unit must be configured
to match temperature unit used by external device.
See Section 6.4.
(2) See Section 9.4.
(3) If previously configured. Polling for pressure is
allowed. See Section 9.4.
98
Configure
ProLink >
(1)
5 Detailed Setup
2 Config field dev var
3 Temperature
Enter Temp unit
Send
Home
Poll?
Configuration >
Temperature
(1)
Enter Temperature units
Apply
Go to Polling
(2)
Setup
Configure temperature compensation
On-Line Menu >
5 Detailed Setup
1 Charize Sensor
9 Ext temp
Enable ext temp
Poll?
Send
Home
Go to Polling
(2)
Setup
®
Micro Motion Model 2400S Transmitters with Analog Outputs
Static?
Disable polling for
(3)
temperature
ProLink >
Configuration >
Temperature
Enter External temperature
Apply
Done
Static?
Enter Static
Temperature
Send
Home
Disable polling for
(3)
temperature
Done