Extreme Networks ExtremeSwitching X440-G2 Series Hardware Installation Manual page 229

4 Push the power supply in until the latch snaps into place.
Caution
Do not slam the power supply into the chassis.
Figure 175: Installing a 750 W AC Power Supply in an EPS-C2 Chassis
Note
If power supplies are not installed in all three slots, be sure to install a cover over each
unoccupied slot. Unoccupied slots must always be covered to maintain proper system
ventilation and EMI levels.
Repeat the procedure to install each additional power supply.
Connecting Redundant Power Cables for the EPS-C2 Chassis
The EPS-C2 chassis can use up to five 2x7-pin redundant power connectors, shown in
connect the power supply to ExtremeSwitching X440-G2 and X620 switches.
Figure 176: EPS-C2 2x7 Pin Redundant Power Cable with Connector Key Tab
ExtremeSwitching and Summit Switches: Hardware Installation Guide
Installing External Power Supplies
Figure 176, which
229