Setting Up The Charging Station - Etesia ET MOWER ETM105 Original User Manual

4• SETTING UP THE CHARGING STATION
For optimal operation, the charging station must be placed in
the main area of the terrain, offering the greatest clearance
possible.
For best results install the base unit on a paved or concrete area.
4•1 DISTANCE TO KEEP
- Minimum 15 m between the station and the peripheral wire
opposite the station.
- A distance of 65 cm between the peripheral wire and the station.
- Set up the cable in a straight line at a distance of minimum 5
metres on either side of the station.
- The station must be set up on a flat terrain.
65 cm
4•2 CABLING
- Feed the cables into the rear of the base unit through the cable glands.
- Connect the two ends of the perimeter wire to the JWIRE terminal
connector on the base unit card.
CONSTITUTIVE COMPONENTS:
Unit card (ref. 33492)
Type of base Card version
Charging arm Cables from the
cables
Min 15m
Peripheral wire
transformer
4•3 ADJUSTING THE CHARGING ARM
Set the height and angle of the charging arm depending on the
position of the robot, the base unit and the slope of the ground to
obtain the best contact possible between the two contacts on the
charge arm and the charge terminals on the robot.
11