Table of Contents
Advertisement
USB Update
A USB ash drive is required for the USB update procedure. Contact the factory for rmware.
1. Copy the rmware le on to a USB ash drive.
2. Plug the USB ash drive into an available USB port.
3. Press the [ RESTART ] button on the system settings page.
4. In the Restart dialog, press [ REBOOT SYSTEM ] and the system will reboot.
CAUTION
It is recommended to place equipment into Off mode prior to rebooting.
Once the system is rebooted, place equipment back into Auto mode.
USB File
USB memory will retain the update le so that it may be used on multiple machines without loss of the le.
Remove the USB memory after the update or the loader will update the rmware on each boot.
USB Troubleshooting
Some memory cards are not read properly by the GCX system. If the rmware le is not detected by the Sys-
tem Loader, then please try another USB ash drive or another format when formatting the ash drive.
Recommended Format: Fat16
75
© Agrowtek Inc. | www.agrowtek.com | Technology to Help You Grow™
Advertisement
Table of Contents
Need help?
Do you have a question about the GrowControl GCX and is the answer not in the manual?
Questions and answers