DPS Telecom NetGuardian 480 G3 User Manual page 26

22
Now you're ready to do the rest of your configuration via LAN. Plug the NetGuardian into your LAN and
see the "Logging On to the NetGuardian " section to continue databasing using the Web Browser.
NOTE: Hold down push button for 20 seconds to bypass TTY login.
7.2 ...via LAN
To connect to the NetGuardian via LAN, all you need is the unit's IP address (Default IP
address is 192.168.1.100).
If you DON'T have LAN, but DO have physical access to the NetGuardian , connect using a LAN
crossover cable. NOTE: Newer PCs should be able to use a standard straight-through LAN cable and
handle the crossover for you. To do this, you will temporarily change your PC's IP address and subnet
mask to match the NetGuardian's factory default IP settings. Follow these steps:
1. Get a LAN crossover cable and plug it directly into the NetGuardian 's LAN port.
2. Look up your PC's current IP address and subnet mask, and write this information down.
3. Reset your PC's IP address to 192.168.1.200. Contact your IT department if you are unsure how
to do this.
4. Reset your PC's subnet mask to 255.255.0.0. You may have to reboot your PC to apply your
Connection through Ethernet port