Additional Ways To Enable/Disable Ec500; How To Enable/Disable One Ec500 Extension At A Time - Avaya EC500 User Manual

Additional Ways to Enable/Disable EC500

Additional Ways to Enable/Disable
EC500
Most EC500 users with the standard EC500 setup will enable/disable all EC500
extensions at one time using their office number during the enable/disable
process; if you have a standard setup, see
procedures. Some non-standard setup users, however, may want to enable or
disable only a single extension (for example, disable call waiting only by entering
the extension number representing their second incoming line or enable their
home office EC500 extension while working at home, but not their cell phone).
The following procedure describes how to enable or disable a single EC500
extension at a time.
NOTE:
When administered to send office caller ID, it remains operational
regardless of whether EC500 is enabled or disabled.
How to Enable/Disable One EC500 Extension at a
Time
To perform this procedure, you need the individual Extension Number(s) of the
phone(s) to be enabled/disabled, and the associated Station Security Code(s).
Perform this procedure from any Touch Tone phone.
1. If you are enabling or disabling EC500 using a phone that is part of your
office telephone system, skip this step. Otherwise, dial the EC500 Access
Number provided by your System Administrator.
You hear a dial tone.
2. Enter the either the EC500 Enable Feature Access Code or the EC500
Disable Feature Access Code, depending on the function you wish to
perform.
You hear a dial tone.
3. Enter the EC500 Extension Number assigned to the phone you want to
enable/disable (or enter your primary Office Number if you want to
enable/disable all EC500 extensions).
4. Press the # button on your phone.
5. Enter the Station Security Code of the EC500 extension being
enabled/disabled.
6. Press the # button on your phone.
You hear a confirmation tone indicating EC500 is enabled/disabled,
depending on which EC500 Feature Access Code you entered in Step 2.
7. Hang up to end the call.
Chapter 4 for standard enable/disable
Issue 3 August 2002 A-3