Removing The 3Rw5 Communication Module From A Level Surface - Siemens SIRIUS 3RW5 Equipment Manual

4.4

Removing the 3RW5 communication module from a level surface

Requirements
● 3RW50 soft starter
● Removed bus connector (Page 57)
● Removed COM connecting cable (Page 53)
● Screwdriver (depending on the drive of the screws)
Procedure
Illustration similar
1. Loosen the head screws on the 3RW5 communication module.
2. Pull out the push-in lugs from the 3RW5 communication module.
Result
You have removed the 3RW5 communication module and can now mount another
3RW5 communication module.
SIRIUS 3RW5 EtherNet/IP communication module
Equipment Manual, 03/2020, A5E45131885002A/RS-AB/002
4.4 Removing the 3RW5 communication module from a level surface
Installing and removing
47