Siemens SIRIUS 3RW5 Equipment Manual page 65

Procedure
①
②
③
④
⑤
⑥
...
1. Set the IP parameters in the 3RW5 communication module.
The following procedures are possible:
– Via SIRIUS Soft Starter ES (TIA Portal) over the local interface on the
– Via the 3RW5 HMI High Feature
Observe the information in Chapter IP parameters (Page 66) and the alternative
procedure with DHCP via a BOOTP/DHCP server tool (Page 62).
2. Integrate the 3RW5 Soft Starter in the configuration software of the controller with the
EDS file as an adapter in the EtherNet/IP system (Page 69).
SIRIUS 3RW5 EtherNet/IP communication module
Equipment Manual, 03/2020, A5E45131885002A/RS-AB/002
Programmable logic controller / scanner
PC or programming device with configuration software of controller
EtherNet/IP
SIRIUS 3RW5 Soft Starter / adapter
PC with SIRIUS Soft Starter ES (TIA Portal)
3RW5 HMI High Feature (accessories depend on 3RW5 soft starter)
: Steps to be taken in the procedure
3RW5 HMI High Feature
Brief overview: Window "Project Navigation" with current project under created
Soft Starter > "Device configuration" > Window "Work area" > Communication module
"EtherNet/IPP" > Inspector window "EtherNet/IP" > Tab "Properties" > Tab "General" >
"Interface"
Further information on the operation of SIRIUS Soft Starter ES (TIA Portal) can be
found in the online help of SIRIUS Soft Starter ES (TIA Portal).
Menu: "Parameter > Communication module > Ethernet/IP > IP address"
Menu: "Parameter > Communication module > Ethernet/IP > Subnet mask"
Menu: "Parameter > Communication module > Ethernet/IP > Router address"
You will find more information on operating the 3RW5 HMI High Feature in the
Equipment Manual of the 3RW5 Soft Starter.
6.2 Configuring the 3RW5 soft starter
Configuring
65