Zoomlion ZA14J Operation And Safety Manual page 43

6) Creep speed indicator
When the Function Speed Control is turned to the creep position, the indicator acts as a
reminder that all functions are set to slowest speed.
The light will be on continuously if the operator selects creep speed.
7) Foot switch indicator
To operate any function, the foot switch must be depressed and the function selected
with 7 seconds. The enable indicator shows that the controls are enabled.
If a function is not selected within seven seconds, or if a seven second lapse between
ending on function and beginning the next function, the enable light will go out and the
foot switch must be released and depressed again to enable the controls. Releasing the foot switch stops
all platform controls.
To avoid serious injury, do not remove, modify or disable the foot switch by blocking or any other
means. Foot switch must be adjusted if malfunctions occur.
8) System fault indicator
Indicate system faults.
9) Glow plug indicator
Indicate the glow plugs are operating.
Start engine until glow plug light goes out.
10) Soft touch indicator
If light goes on, soft touch function activates.
11) Drive direction confirm indicator
When the boom is swung over the rear tires or further in either direction, the Drive
Orientation indicator will illuminate when the drive function is selected.
This is a signal for the operator to verify that the drive control is being operated in the
proper direction (i.e. controls reversed situation).
2-15