Section 5 Maintenance; General; Maintenance Symbols Legend; Pre-Start Inspection - Zoomlion ZA14J Operation And Safety Manual

5.1 General

Observe and Obey:
a) Only routine maintenance items specified in this manual shall be performed by the operator;
b) Scheduled maintenance inspections shall be performed by qualified service technicians, according
to the manufacturer's specifications and the requirements listed in the responsibilities manual;
c) Disposal of materials should be according to the regulations of government and relevant
environmental protection administration;
d) Use only ZOOMLION approved replacement parts. ZOOMLION assumes no responsibility for
hazards occurred to equipment and personnel caused by the use of unauthorized parts.

5.1.1 Maintenance symbols legend

The following symbols have been used in this manual to help communicate the intent of the instructions.
When one or more of the symbols appear at the beginning of a maintenance procedure, it conveys the
meaning below.
Indicates that tools will be required to perform this procedure.
Indicates that new parts will be required to perform this procedure.
Indicates that a cold engine is required before performing this procedure.

5.1.2 Pre-Start inspection

Be sure operator's, safety, and responsibilities manuals are complete, legible, and in the storage
a)
container located on the machine;
b) Be sure all decals are in place and legible;
c) Check for hydraulic oil leak and proper oil level. Add oil if needed. See Maintenance section;
d) Check for battery fluid leaks and proper fluid level. Add distilled water if needed after battery
charged. Check the following components for areas for damage, improperly installed, or missing
parts and unauthorized modification:
1) Electrical components, wiring, and electrical cables;
2) Hydraulic hoses, fittings, cylinders, and manifolds;
3) Drive motor/motor;

SECTION 5 MAINTENANCE

5-1