Platform Leveling - Zoomlion ZA14J Operation And Safety Manual

4.2.2.1 Traveling forward and reverse
a) At Platform Controls, pull out Emergency Stop switch, start the engine, and activate
foot switch;
b) Position Drive/Steer control to 'Forward' or 'Reverse' hold for duration of
forward or reverse travel desire.
This machine is equipped with travelling direction indicator lights. The indicator lights on platform
console to inform that upper boom is over front axle (Steer Wheels), steer and drive controls will move
in opposite direction than indicated on machine placards.
If the indicator is illuminated, operate the Drive function in the following manner:
a) Check blue and yellow arrow on platform control panel and on chassis match
or not, confirm the travelling direction;
b) Toggle and loosen travelling direction confirmation switch. Operate the handle to
drive as needed within 5 seconds.
4.2.2.2 Steering
At Platform Controls, pull out Emergency Stop switch, start the engine and activate foot
switch.
Position the travelling/steering handle to the left or right side to turn wheel left or right accordingly.

4.2.3 Platform Leveling

Only use the platform leveling function for slight leveling of the platform when the platform is in
low position. Incorrect use could cause the load/occupants to shift or fall. Failure to do so could
result in death or serious injury.
Before platform level adjustment, identify the position of the platform.
The Level Up or Down-Position the platform/Level control switch Up or Down and
hold until the platform is level.
4-4