Zoomlion ZA14J Operation And Safety Manual page 32

5) Jib lift switch (if equipped)
Provide raising and lowering of the jib.
6) Platform rotate switch
Provide platform rotate controls.
Only use the platform leveling override function for slight leveling of the platform when platform
is lowered. Incorrect use could cause the load/occupants to shift or fall. Failure to do so could
result in death or serious injury.
7) Power/Emergency stop switch
A three position switch allows the operator to adjust the automatic self-leveling
system. This switch is used to adjust platform level in situations such as
ascending/descending a grade.
When the machine is shut down, the power/emergency stop switch must be positioned to the off
position to prevent draining the batteries.
8) Power/Emergency stop switch
A two position red
PLATFORM/GROUND SELECT switch when pulled out (on). When pushed in
(off), power is shut off to the PLATFORM/GROUND SELECT switch.
9) Platform/Ground select switch
The three position key operated switch supplies power to the platform control console when positioned
to PLATFORM. With the switch key turned to the GROUND position only ground controls are
operable. The three position key operated switch positions to middle, platform mode and ground mode
shut off at the same time.
2-4
mushroom shaped switch supplies power to