26.4 Changing the OEM's password
P
P
/reset
P
/reset
P
P
26.5 Use of the parameter level
The parameters stored in the LMV37.4... basic unit can be displayed and changed on the parameter level.
Normally, all parameters have been set by the burner manufacturer – with the exception of those for the fuel
train and for air-fuel ratio control.
A description of parameter level 400, which is used for setting the fuel train and the fuel-air ratio curve, is
given in chapter «Air-fuel ratio curves – settings and commissioning».
146/213
Building Technologies
HVAC Products
V
h min s
%
V
h min s
%
V
h min s
%
V
h min s
%
V
h min s
%
Basic documentation LMV37.4...
26 Parameter level
Parameter 042: flashes.
Press
to go to level c: for password changes.
/reset
Letter n: for n ew.
Proceed as described in section «Entering the
password»and enter the new password (5 characters).
After entry of the last character, the password must be
confirmed by pressing
/reset
Letter r: for r epeat.
Proceed as described in section «Entering the
password»and repeat entry of the new password.
After entry of the last character, the password must be
confirmed by pressing
/reset
SEt confirms that the new password has been saved.
Parameter 042: flashes again.
.
.
CC1P7546en
01.12.2009