Siemens LMV37.4 Series Basic Documentation page 178

To the next curvepoint
A
and
or
as well as
and
F
and
or
To the next curvepoint
178/213
Building Technologies
HVAC Products
P
V h min s
A
P
V h min s
P
V h min s
P
V h min s
Basic documentation LMV37.4...
26 Parameter level
Curvepoint P2 can only be adjusted when
symbol ▲ or ▼ is no longer highlighted.
Fuel valve V2 is switched on.
Keep depressed and, for VSD,
A
.
A
%
Press or
As soon as symbol ▲ or ▼ is no longer
highlighted, the next curvepoint P2of can be
selected with
Curvepoint P2of is now adjusted.
The system remains at P2.
Adjust the switch-off point with no travel.
Now, the curvepoint is approached dynami-
cally when traveling from P2 to P1 .
%
As soon as symbol ▲ or ▼ is no longer
highlighted, the next curvepoint P1 can be
selected with
Automatic mode is released when, after
reaching P1 , the curve settings are quit with
Esc .
If the settings are aborted earlier ( Esc or
shutdown due to fault), start prevention OFF
%
UPr is still active until all curvepoints are set.
ESC
As soon as symbol ▲ or ▼ is no longer high-
lighted, Esc can be pressed a second time.
%
Back to the previous
curvepoint
and
F
to adjust the value.
.
Back to the previous
curvepoint
.
Back to the previous curve-
point
CC1P7546en
01.12.2009