Button In Handle, Moving Into Installation Position - Volkswagen Golf 2015 Repair Manual

Note
♦ There is the possibility that the button can be pressed into the
handle. Never install the handle when the button is pressed in.
Move the button in the installation position. Refer to
♦
⇒ 2.4 Button in Handle, Moving Into Installation Position ,
page 53 .
A new handle is delivered with an assembly fastener. Pull out
♦
the safety catch in direction of -arrow- just before installing the
new handle.
– Install the handle with a new clamp -arrow-. Do not clamp the
clamp yet.
– Press the button after installing it.
Note
If the button stays in the handle after being pressed, this means
it was installed incorrectly. If this happens, remove the handle
again and move the button in the installation position again. Refer
to
⇒ 2.4 Button in Handle, Moving Into Installation Position ,
page 53 . Install the handle again.
– If the button after being pressed return to its starting position,
the clamp can be clamp off using Hose Clamp Pliers -
VAG1275A- .
– Connect the connector.
– Clip on the cover.
2.4 Button in Handle, Moving Into Installa‐
tion Position
If the button was pushed in by mistake, the installed position can
be set again.
Golf 2015 ➤ , Golf Variant 2015 ➤
Direct Shift Gearbox - Edition 09.2015
2. Selector Mechanism
53