Volkswagen Golf 2015 Repair Manual page 87

Note
Use pliers to remove the lock washer from the cable bracket.
♦
Do not use a sharp-edged lever. Otherwise the selector lever
cable could get damaged.
Remove the cable bracket -2- from the transmission, if nec‐
♦
essary. Remove the bolts -1- and the lock washer -3-.
Replace the bolts -1- and the lock washers.
♦
Bolt tightening specification -1- 20 Nm +90°.
♦
Caution
Risk of damaging the selector lever cable.
♦ Remove the selector level cable from the cable bracket
when lowering transmission.
♦ Do not bend or kink the selector lever cable.
– Place a lint-free cloth on to transmission fluid cooler and trans‐
mission to absorb escaping coolant.
WARNING
Risk of scalding due to hot steam and hot coolant.
♦ The cooling system is under pressure when the engine is
warm.
♦ Reduce the pressure by covering the coolant reservoir cap
with cloths and carefully opening.
– Clamp the coolant hose with the Hose Clamps - Up To 25mm
- 3094- .
– Loosen the hose clamps -arrows- and remove the coolant ho‐
ses from the transmission fluid cooler.
– If equipped, remove the bolts -1- and move the Transmission
Coolant Valve - N488- to the side. Tightening specification.
Refer to
⇒ 3.3 Transmission Tightening Specifications , page 96
– Seal the transmission fluid cooler connections with plugs tak‐
en from Engine Bung Set - VAS 6122- .
Golf 2015 ➤ , Golf Variant 2015 ➤
Direct Shift Gearbox - Edition 09.2015
.
3. Transmission, Removing and Installing
83