Volkswagen Golf 2015 Repair Manual page 138

Golf 2015 ➤ , Golf Variant 2015 ➤
Direct Shift Gearbox - Edition 09.2015
– Install the seal all the way in without tilting it.
Note
Press the flange shaft against the transmission so that the bolt in
the threaded piece of the differential touches.
– Insert the flange shaft and secure it with bolts.
– Install the ball joint. Refer to ⇒ Suspension, Wheels, Steering;
Rep. Gr. 40 ; Lower Control Arm and Ball Joint; Overview -
Lower Control Arm and Ball Joint .
– Fasten the drive axle to the flange shaft. Refer to ⇒ Suspen‐
sion, Wheels, Steering; Rep. Gr. 40 ; Drive Axle; Drive Axle,
Removing and Installing .
– Install the heat shield over the right drive axle, if equipped.
Refer to ⇒ Suspension, Wheels, Steering; Rep. Gr. 40 ; Drive
Axle; Drive Axle, Removing and Installing .
– Check the fluid level and fill if necessary. Refer to
⇒ 9.1 Transmission Fluid Level, Checking , page 113
– Install the noise insulation. Refer to ⇒ Body Exterior; Rep. Gr.
66 ; Noise Insulation; Overview - Noise Insulation .
Tightening Specifications
♦ Flange shaft to transmission. Refer to
⇒ 1.1 Component Location Overview - Seals , page 128
134
Rep. Gr.39 - Final Drive, Differential
.
.