Volkswagen Golf 2015 Repair Manual page 118

Golf 2015 ➤ , Golf Variant 2015 ➤
Direct Shift Gearbox - Edition 09.2015
Shorten the Bleed Pipe on the Adapter For Oil Filling - VAS6262A-
as Follows:
– Shorten the pipe to dimension -a-. This assures the pipe on
the Adapter For Oil Filling - VAS6262A- will not touch the bot‐
tom on some fluid containers.
Dimension -a- = 210 mm
Note
Dimension -a- is measured starting from the shaft (the green sur‐
face) on the Adapter For Oil Filling - VAS6262A- .
If dimension -a- is greater than 210 mm:
– Make a mark on the bleed pipe, dimension -a-, and cut it, with
for example the Brake Line Tool Kit - Pipe Cutter -
VAS6056/2- .
Requirements
♦ The vehicle is level and all hoist supports are the same height.
♦ Noise insulation is removed. Refer to ⇒ Body Exterior; Rep.
Gr. 66 ; Noise Insulation; Overview - Noise Insulation .
♦ Vehicle Diagnostic Tester is connected
♦ To begin working, the fluid temperature should not be higher
than 45 °C (113 °F).
♦ Test temperature: 35 ° to 45 °C (95 ° to 113 °F).
Checking
– Vehicle Diagnostic Tester Connect and identify the vehicle in
.
Guided Functions
– Select
DSG transmission
– Select
Check Fluid Level
Note
Let the transmission cool down if the fluid temperature is higher
than 45 °C (113 °F).
The engine is idling in neutral and the selector lever is in P .
– Move the Used Oil Collection and Extraction Unit -
SMN372500- or a Drip Tray under the transmission near the
transmission fluid drain and check plug.
114
Rep. Gr.34 - Controls, Housing
.
.