Volkswagen Golf 2015 Repair Manual page 60

Golf 2015 ➤ , Golf Variant 2015 ➤
Direct Shift Gearbox - Edition 09.2015
Loosen the adjusting screw -arrow-.
– Remove the lock washers -A and B-. The lock washers must
later be replaced when adjusting selector lever cable.
Use pliers to remove the lock washer -B-. Do not use a sharp-
edged lever. Otherwise the selector lever cable could get dam‐
aged.
– Remove the center tunnel heat shield under the gearshift
mechanism. Refer to ⇒ Body Exterior; Rep. Gr. 66 ; Molding/
Trim/Extensions/Trim Panels; Floor Heat Shield, Removing
and Installing .
– Remove the bracket -A-, if equipped.
– Remove the nuts -arrows- in the vehicle interior.
– Remove the selector mechanism -B- with the selector lever
cable and selector housing downward.
Installing
Install in reverse order of removal. Note the following:
Note
Do not bend or kink the selector lever cable.
♦
Do not lubricate the selector lever cable.
♦
After installation, the selector lever cable movement must be
♦
checked and adjusted.
– Install the heat shield under the gearshift mechanism. Refer
to ⇒ Body Exterior; Rep. Gr. 66 ; Molding/Trim/Extensions/
Trim Panels; Floor Heat Shield, Removing and Installing .
56
Rep. Gr.34 - Controls, Housing