USB connectors
The USB connectors are used for connecting Smart IDs, exporting test results to a flash
drive, or for performing firmware upgrades from a flash drive.
POTS connector
The POTS connector is used on the ONX-580 / ONX-580P modules for POTS testing.
Network connectors
Two Ethernet/Network ports are used to connect to Ethernet networks to allow testing
(such as hub flash, port discovery, and ping), synchronize with StrataSync, upgrade
software, and remotely connect to the OneExpert.
RJ45 Wiring connector
The RJ45 wiring connector is used on the ONX-580 / ONX-580P for:
RJ45 wire ID
y
RJ45 toning
y
Wire mapping to smart remote
y
CAUTION: DAMAGE TO INSTRUMENT
Never insert an RJ-11 plug into the RJ-45 connector of the
OneExpert; doing so may cause permanent damage to the
connector.
May 2020
OneExpert DSL User's Guide
22052280, Rev. 016
Chapter 2 Quick Tour
37