Federal Communications Commission (Fcc) Notice - Viavi OneExpert DSL User Manual

The OneExpert DSL includes third party software licensed under the terms of separate open
source software licenses. By using this software you agree to comply with the terms and
conditions of the applicable open source software licenses. Software originated by VIAVI is not
subject to third party licenses. Terms of the VIAVI Software License different from applicable
third party licenses are offered by VIAVI alone.

Federal Communications Commission (FCC) Notice

This product was tested and found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This product generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instruction manual, may cause harmful interference
to radio communications. Operation of this product in a residential area is likely to cause
harmful interference, in which case you will be required to correct the interference at your own
expense.
The authority to operate this product is conditioned by the requirements that no modifications
be made to the equipment unless the changes or modifications are expressly approved by
VIAVI.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
In order to maintain compliance with the limits of a Class A digital device VIAVI requires
that quality interface cables be used when connecting to this equipment. Any changes or
modifications not expressly approved by VIAVI could void the user's authority to operate the
equipment.
CAUTION:
– To comply with FCC RF exposure compliance requirements, a separation distance of at
least 20 cm must be maintained between the antenna of this device and all persons.
– This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
May 2020
OneExpert DSL User's Guide
22052280, Rev. 016 iii