About Ethernet Testing - Viavi OneExpert DSL User Manual

Chapter 8 Ethernet Testing

About Ethernet testing

In Ethernet mode, you can use the OneExpert DSL to emulate Ethernet terminal equipment
by connecting to an Ethernet LAN or to the Ethernet port on the customer's modem. After
connecting to the circuit, you can then test for connectivity and throughput.
You can also ping through the modem to a network switch or web address to test for
connectivity and run Traceroute to record and observe the route of traffic through the
network.
From the Main menu, select Ethernet.
The Ethernet tests involve the following steps:
Specifying test settings
y
Connecting to the line
y
Performing tests
y
Viewing results
y
Specifying Ethernet settings
Before you begin testing, make sure the test settings on the OneExpert DSL match the settings
of the line that you are testing.
To access the setup screen, select the Tests & Settings system key or use the tray menu
y
(swipe down from the top or press the tray system key).
196
OneExpert DSL User's Guide
22052280, Rev. 016 May 2020