Using A Pc Keyboard - Viavi OneExpert DSL User Manual

Chapter 3 Utilities
Connecting to your ONX via VNC on your PC
After you have established an Ethernet or WiFi connection and set up the ONX for remote
operation, you can launch the VNC viewer program to operate the ONX on your computer.
1. Download a VNC viewer application and launch it on the PC.
2. In the viewer's server address field, enter the OneExpert's IP address, and click OK.
A password entry box
appears.
3. Enter the VNC password
you noted before,
viavi-vnc (found in the
Remote Operation menu)
and then click OK. The
OneExpert user interface
appears in the VNC viewer,
and works similarly to
using the unit itself. See the next section for details.
4. If the message, "Failed to connect to server" appears, the VNC viewer was not able
to communicate with the OneExpert. If this happens, try the following solutions:
Make sure you are using the correct IP address for the OneExpert
y
From the PC or laptop, ping the OneExpert IP address to verify the network
y
link is working. If the link is not working, restart the OneExpert and try again..

Using a PC keyboard

After you have connected to the OneExpert from a laptop or PC using the VNC viewer, you
can use the computer's mouse or keyboard to control the OneExpert.
The following table shows how the PC keys map to the OneExpert keypad.
PC key
Escape
80
OneExpert key
F1–F4 Correspond to the OneExpert system keys
F5 Home
F6 Tray menu
F7 AutoTest
Cancel
Enter OK
OneExpert DSL User's Guide
22052280, Rev. 016 May 2020